Adjustable Bed Parts & FAQs

Adjustable Bed Parts Available:

R2T4 Remote – for Genius or Classic beds purchased after 2001

Conversion Kits – for Genius beds purchased prior to 2001 and the remote no longer works. There is no longer remotes or modules available for these adjustable beds. The conversion kit consists of:  a module, remote, power cord and jumper plugs.

Rubber Caster Cups – Adjustable bed parts like the Cups to put under the casters of the bed when on hardwood or linoleum flooring to help the bed not to slide on the floor.

Glides – for Classic, Wall Hugger & Pillow Tilt beds for lowering to the ground. These will replace the legs & casters on the bed.


FAQ’s & Troubleshooting

My bed no longer works?

  • Is the indicator light still working? If so, then unplug the bed and plug back in and then try to adjust your bed. If it still does not work, then you will unplug the other bed (if you have one) so that it does not pick up the programming.
    • For Genius or Classic (grey remote), take the remote for the bed that was not working, locate the upper left button (line w/arrow) and bottom left button (head w/line) and push down on these 2 buttons simultaneously and hold for approximately 10 seconds, release the buttons and try to adjust bed. If all is good don’t forget to plug other bed back in.
    • For Wall Hugger and Pillow Tilt beds you will do the same as above but  use the top left button (foot up) and 2nd button from the bottom on the left (preset button to full incline).
  • If the indicator light is not working then replace the batteries and if need be follow the steps above.
  • If after replacing the batteries and the indicator light still does not work, you will require a new remote.

 


My massage is noisy?

  • If you are able, turn bed over and tighten any bolts holding the massage motors in place. The head or foot of my bed will not raise.
  • If you purchased your bed prior to 2008, look and see if you have any broken plastic under your bed.
    • If so,  this  indicate the Acme Nut has broken.
    • The Acme Nut goes on the shaft of the lift motor and allows the head or foot of the bed to raise.

 


Can I program 2 beds to 1 remote?

  • Yes you can. To do this, you unplug both beds & plug them back in (electric reset is needed).
    • For Genius or Classic (grey remote) take the remote for the bed that was not working, locate the upper left button (line w/arrow) and bottom left button (head w/line) and push down on these 2 buttons simultaneously and hold for approximately 10 seconds, release the buttons and try to adjust bed.
    • For Wall Hugger and Pillow Tilt beds,  do the same as above but use the top left button (foot up) and 2nd button from the bottom on the left (preset button to full incline). If they do not both program right away, repeat the steps above until they both pick up the same frequency.
  Get a Free Quote

Take the Sleep Survey

Testimonials

Learn About Pillow Tilt
Watch us on YOUTUBE Like Ultramatic on Facebook Connect with G+